Model 3001 EVO 13” Shear Cutter by Accucut

$1,475.00
Shipping calculated at checkout.

3003 Blade Choice: Metal

Metal
Plastic
SKU: MAC-ACC3001EVO/13M
Categories: All Products
amazon paymentsamerican expressapple paydankortdiners clubdiscoverdogecoindwollaforbrugsforeningeninteracgoogle payjcbmaestromasterpaypalshopify payvisa

The new 3001EVO is the newest shear in the Model 3001 series. It is a 13" guillotine shear but with a reduced overall size and price. A 7" version is now available. The details are below.

freight Quoted separately

The original 3001 13 " Guillotine Shear was introduced by Accucutter® in 1999. Since it's introduction, the 3001 Series has proved to be the most durable and accurate shear on the market for the price. However, with the rising costs of raw materials the original 3001 13 " Guillotine Shear has become too expensive for some applications.

In an effort to continue to offer an affordable guillotine shear without sacrificing quality, Accucutter® conducted a complete review and evaluation of the original 3001 shear. The result of the effort is a new shear that is smaller and 35 pounds lighter than the original but still retains all the unique features of the original. Like all shears bearing the Accucutter® name, the new 3001EVO is made totally in the USA at our plant in Pennsylvania. The shear still has a cut width of 13 " and a 12" table.

"Flip-Up Hold Down"
Accucutter®'s
exclusive "Flip-Up Hold-Down" is standard on the 3001EVO. When in the down position, it automatically applies pressure to the material to facilitate smooth, accurate cutting. When necessary, the hold-down may be flipped up out of the way to permit easy access to the blades.

Movable Handle
The shear handle may be installed on the left or right of the shear enabling right handed and left handed operators to use the same shear.

Precision Drop-Off Bar
The Precision Drop-Off Bar is full width and is an invaluable aid for making accurate, repetitive cuts. It is mounted to the top blade carrier and moves up and down with the top blade like the rear gauge on many larger guillotine shears. It is above the material and doesn't interfere with the material as it falls away from the shear after it is cut. It slides on two alignment rods and is locked in position by turning a knob on each rod.

Step Ruler
The typical ruler is a stamped piece of thin metal. The ruler from Accucutter® is machined from a thick, solid piece of steel. There are six separate steps involved in its manufacture with the last being a precision grinding of the front edge to insure that the ruler is straight and true. Because of its thickness, it is very stable, and the edge will not lift or distort allowing material to slide underneath the ruler. Lastly, the ruler is stepped to place the measuring edge close to the work surface for easier reading. The ruler is graduated in 1/16th's of an inch.

Blade Adjustment
The 3001EVO uses the same blade system pioneered by Accucutter® on its 2001 Bench Shear. The blades are mounted with tapped bolts rather than the old fashion nut and bolt system, and the bottom blade is adjusted with set screws instead of eccentrics. A much safer, quicker and simpler method of installing and adjusting the blades.

Shear Capacity:
· Aluminum................................................. .040"
· Engravers Brass........................................ .025"
· Flexible Plastic......................................... .063"
· Brass Plated Steel.................................... .020"

Shipping Quoted Separately